8
SET MODES
8-5
Extra High Power
Select whether or not to display and select EXH (Extra
High) as the highest power of the transceiver.
(Default: EXH.OF)
• EXH.OF: Displays and selects High as the highest
power level of the transceiver.
• EXH.On: Displays and selects Extra High as the
highest power level of the transceiver.
Key-touch beep
Set the confirmation beeps to between 1 and 3.
To turn OFF the confirmation beeps, select “bEP.OF.”
(Default: bEP. 2)
• When changing the beep level, beeps sound at the
level.
Time-out timer
To prevent accidental prolonged transmission, the
transceiver has a time-out timer. The function inhibits
continuous transmissions longer than the set time
period (1 ~ 30 minutes).
(Default: tot. 5)
• tot.OF:
Turns OFF the function.
• tot. 1 ~ 30: Transmission is cut OFF after the set
time period ends.
Approximately 10 seconds before the Time-out timer
is activated, the transceiver emits a beep tone as a
warning.
BE CAREFUL!
When using the BP-263
battery
case
, the batteries will become hot if this Time-out
Timer function is turned OFF or set to a long time
period, and transmission is made for long periods.
The initial Set mode can be accessed at power ON,
and allows you to set seldom-changed settings. In this
way, you can “customize” the transceiver to suit your
preference and operating style.
1. While holding down [
Y
] and [
Z
], hold down [ ] for
1 second to enter the Initial Set mode.
2. Push [
Y
] or [
Z
] to select the desired item.
3. Rotate [VOL] to select an option or value.
4. Push [# ENT] to exit the initial Set mode.
Auto power-OFF
The transceiver can be automatically turned OFF,
when no key operation is performed for the specified
period of time. 30 minutes, 1 hour, 2 hours and OFF
are selectable.
(Default: POF.OF)
• POF.OF:
Turns the function OFF.
• POF.30/1H/2H: The transceiver is automatically
turned OFF, when no key operation
is performed for the specified time
period.
NOTE:
The setting is retained, even if the
transceiver is turned OFF by the Auto Power OFF
function. To cancel the function, select “POF.OF.”
Lockout
Set the transmission lockout (temporary transmission
inhibit) capability.
(Default: RLO.OF)
• RLO.OF: Turns OFF the function.
• RLO.RP: The transmit is inhibited when a signal
with an unmatching subaudible tone is
received.
• RLO.bU: Transmit is inhibited when a signal is
received.
Squelch delay
Set the squelch delay to short or long. The delay
prevents the squelch from repeatedly opening and
closing, while receiving the same signal.
(Default: Sqd. S)
• Sqd. S: Short squelch delay.
• Sqd. L: Long squelch delay.
Using the Initial Set mode
Initial Set mode items
