3
ADVANCED OPERATION
3-2
Adjusting the audio level
z
Rotate [VOL]* to adjust the audio level.
• The display shows the audio level while adjusting.
L
If the squelch is closed, hold down [MONI] while
adjusting the audio level.
[DIAL]
[VOL]
* Use [VOL] or [
Y
]/[
Z
], depending on the setting of the “Dial
assignment” in the Initial Set mode. (p. 8-6)
Selecting passband width
Set both the transmission and reception passband
width to wide or narrow.
1. Push [FUNC], and then push [SET] to enter the
Set mode.
2. Push [
Y
] or [
Z
] to select the passband width item
(W/n).
3. Rotate [VOL] to select the passband width.
• “W”: Wide (FM mode)
• “n”: Narrow (FM-N mode)
4. Push [# ENT] to exit the Set mode.
The “Passband width” item in the Set mode
(FM mode is selected)
(FM-N mode is selected)
[VOL] function assignment
[VOL] can be used as a channel selector instead of
[
Y
] and [
Z
], to suit your preference. However, when
[VOL] functions as a channel selector, [
Y
] and [
Z
]
function as volume controls.
1. Hold down [ ] for 1 second to turn OFF the power.
2. While holding down [
Y
] and [
Z
], turn ON the power
to enter the Initial Set mode.
3. Push [
Y
] or [
Z
] to select the dial assignment item
(tOP).
4. Rotate [VOL] to select an option.
5. Push [# ENT] to exit the Initial Set mode.
[VOL] and [
Y
]/[
Z
] function as described below,
depending on the option.
Option
[VOL]
[
Y
]/[
Z
]
tOP.VO
Volume control
Channel selector
tOP.di
Channel selector
Volume controls
The “Dial assignment” item in the Set mode
[VOL] functions as the volume control.
[VOL] functions as the channel selector.