5
16
dPMR™ OPEARTION
D
Transmitting
You can make a call to a station that has the same
Common ID. Other digital mode transceivers on the
channel will not receive the call that does not match
their Common ID.
Before making a call, wait until the channel is clear to
avoid interference.
Using [PTT]:
1) Rotate [Rotary Selector] to select a channel.
2)
Push [PTT] to call a station.
3)
Hold down [PTT] and speak at your normal voice
level.
4)
Release [PTT] to receive.
5) Push [Clear]* to send a ‘Disconnect’ signal to
terminate the call.
Using the [S-Ring/C-Ring]:
1) Rotate [Rotary Selector] to select a channel.
2)
Hold down [S-Ring/C-Ring] for 1 second to call a
station.
3)
Hold down [PTT] and speak at your normal voice
level.
4)
Release [PTT] to receive.
5) Push [Clear]* to send a ‘Disconnect’ signal to
terminate the call.
Using the [Call]*:
1) Rotate [Rotary Selector] to select a channel.
2) Push [Call]* to send a call request.
3)
Hold down [PTT] and speak at your normal voice
level.
4)
Release [PTT] to receive.
5) Push [Clear]* to send a ‘Disconnect’ signal to
terminate the call.
Receiving and transmitting (Continued)
NOTE:
To insure the readability of your signal:
1. After pushing [PTT], pause briefly before you start
speaking.
2. Hold the microphone 5 to 10 cm from your mouth,
and then speak at your normal voice level.
NOTE:
After receiving a call request, a ringer sounds on a
receive transceiver.
[Rotary Selector]
[PTT]
* Assign the function to a programmable key by
using the CS-F29DR cloning software (purchase
separately). Ask your dealer for details.
