Icom IC-7600, Инструкция по эксплуатации, Страница: 97 / 196

88
4
RECEIVE AND TRANSMIT
4
• Scanning during dualwatch
Scanning operates only for the main readout.
To operate the scan during dualwatch, scan on the
main readout and use the sub readout for your QSO
using both dualwatch and split frequency operation.
q
Program the desired programmed scan edges in
the same amateur band.
See page 109 for programming.
• If you plan to operate a ∂ F scan, programming the
scan edges may not be necessary.
w
Push [SPLIT] to turn the split frequency function
ON.
• “ ” appears.
e
Select VFO mode for the main readout.
r
Set the desired operating frequency for the main
readout.
t
Hold down
[DUALWATCH] for 1 second.
• “ ” appears.
• Equalized receive frequency and operating mode
appear on the sub band readout and the dualwatch
function is turned ON.
y
Push
[SCAN] (F-5) to select the scan screen.
• Push
[EXIT/SET] several times to close any multi-
function screens, if necessary.
u
Push
[PROG] (F-1) or [
∂
F] (F-2) to start the
programmed scan or ∂ F scan, respectively.
• Scan activates on the main readout between the
programmed scan edges or within the ∂ F span.
• Transmitting on the sub readout stops the scan.
i
To cancel the scan, push [EXIT/SET].
F-1 F-2 F-5 EXIT/SET
DUAL
WATCH
SPLIT
PROG SCAN ∂ F