Icom IC-7600, Инструкция по эксплуатации, Страница: 44 / 196

35
3
BASIC OPERATION
Band edge warning beep (Continued) D
To programming the band edge:
q
Perform the steps
q
to
t
as shown above, then select
either “ON (User)” or “ON (User) & TX Limit” setting.
• [BAND] appears above the function switch (F-5).
w
Push [BAND] (F-5) to open the band edge screen.
e
Push [ Y ] (F-1) or [ Z ] (F-2) to select the desired
band edge.
• Push [ Ω ≈ ] (F-3) to select the upper and lower band
edge frequency entry cell.
• Push [INS] (MF6) to insert a new blank band edge line.
• Hold down
[DEL] (MF7) for 1 second to delete the
selected band edge line.
r
Input the desired frequency with the keypad, then
push [F-INP•ENT] .
• Push
[GENE •]
to input decimal point (“.”) between the
MHz and kHz digits.
• Program each channel from left to right and each
frequency must be higher than the preceding
frequency.
• The frequency that is duplicated, or out of an amateur
band, cannot be programmed.
• If you want to return the band edge frequencies to their
default (initial) value, hold down
[DEF] (F-4) for 1 second.
The band edge initialize screen appears, then hold
down
[OK] (F-5)
for 1 second to initialize all band edge
frequency settings.
t
Push [EXIT/SET] to exit the set mode.
NOTE:
All frequency ranges are set to default. So
you should delete or change it to add the desired
band edge frequency.
Main dial
EXIT/SET
F-5
F-1 F-2 F-3 F-4
DEF
[INS] [DEL]
Keypad
OK
/
BAND
• Band edge screen