Icom IC-7200, Расширенные инструкции

Страница: 50 / 127

4-5
4
RECEIVE AND TRANSMIT
Connect a paddle, straight key or external electron-
q
ic keyer as described on page 2-8.
Hold down
w
F-INP ENT
BAND
for 1 second, then push a
band key to select the desired band.
Push
e MODE
to select the CW mode.
• Hold down
MODE
for 1 second to toggle between the
CW and CW-R modes.
Rotate
r
[DIAL] to tune in a desired signal.
• The S-meter displays the received signal strength when
a signal is received.
Rotate the
t
[AF] control to set the audio to a com-
fortable listening level.
Set CW break-in mode and the CW delay time in
y
the Set mode.
Key to transmit, using the paddle, straight key or
u
external electronic keyer to send your CW signals.
• “ ” appears.
• The Po meter displays the transmit output power.
Stop keying to receive.
i
Band keys
[DIAL] [AF]
“ CW” or “CW-R” appears.
Appears while transmitting.
[M-CH]
Appears when semi break-in is selected.
Semi break-in (default: OFF)
7.5 dots (default)
q
Hold down
M-CH/RIT
SET
for 1 second twice to enter
the Set mode.
w
Rotate [M-CH] to select “ BK-IN ” to set the CW
break-in mode.
e
Rotate [DIAL] to select full break-in, semi
break-in or OFF.
• FL : full break-in
• SE : semi break-in
• OF : break-in OFF
r
Rotate
[M-CH]
to select “
BK-DELAY
” to se-
lect the CW delay time when the semi break-in
mode is selected in step
e
.
t
Rotate
[DIAL]
to set the desired delay time.
y
Continue to set the keyer settings in the Set
mode, if necessary. (p. 10-15)
u
Push
M-CH/RIT
SET
to exit the Set mode.
“ CW ” or “ CW-R ” appears.
Appears when semi break-in is selected.
Appears while transmitting.
Set mode
■
Operating in the CW mode
Previous view