4
SCAN
10
Repeater scan
The Repeater scan is used not only to search for a
signal on the repeater channels, but also to access
a repeater by automatically transmitting in sequence.
The Repeater scan detects repeaters that can be
accessed in the area, even if the repeater is not used.
The Repeater scan detects signals only on
channels 1 to 8 (channel 5 not included) and 41 to
48. The scan will stop if any activity is detected on a
repeater channel, even if a repeater is not present.
Activity such as stations operating in Simplex mode
on a repeater transmit channel may give a false
indication that a repeater is present.
q
Select the desired repeater channel and then hold
down
for 2 seconds to start the Repeater scan.
Blinks
w
When a signal is received on a repeater channel,
the scan stops.
• After automatically transmitting, 3 high beeps sound
when a signal is received, and 3 low beeps sound when
no signal is received.
e
Push
to cancel the scan.
• While transmitting, you cannot cancel the Repeater
scan.
D
Repeater scan flow
Scan
Scan
Searches for
signal on the
repeater output
channels.
Automatically tries to access
the repeater. (0.5 seconds)
Waits for a signal from the
repeater. (0.5 seconds)
Automatically tries to access
the next repeater.
(When no reply signal is received.)
Scan is automatically cancelled.
Scan start
channel
NOTE:
Scan excludes the emergency repeater channel 05.
• STATUS INDICATOR
blinks green.
• STATUS INDICATOR
blinks green and red
alternately.
