New2001
43
New2001
New2001
SCAN OPERATION
6
BASIC MANUAL
■
VFO mode scan
1. Push [V/M] several times until you enter the VFO mode.
2. Hold down [SCAN] for 1 second.
•Opens the Scan Type Select window.
L
If you hold down [SCAN] for 3 seconds, the last selected
scan starts.
3. Rotate [DIAL] to select a scan type, then push [
ï
].
•The scan starts.
L
The decimal point and the selected scan type icon blink.
L
When receiving a signal, the S-meter displays the received
signal strength.
4. Push [SCAN].
•Cancels the scan.
D
Scan type
The VFO mode scan has 6 scan types.
•ALL:
Full scan
•BAND:
Band scan
•P-LINK0 ~ 9: Program link scan
•P00 ~ 24:
Program scan
•DUP:
Duplex scan
(Displayed only when duplex is set.)
•TONE:
Tone scan
(For the Tone Squelch scanning)
L
The frequencies that are set as a Skip channel (PSKIP)
are skipped during a scan. (p. 44)
L
When the “Program Skip” item is set to “OFF,” the Skip
channel frequencies are not skipped. (p. 29)
(Scan >
Program Skip
)
Scanning is a versatile function that can automatically
search for signals. A scan makes it easier to locate stations
to contact or listen to, or to skip unwanted channels or
frequencies.
This section describes the basic scan operation.
TIP:
• During a scan, rotating [DIAL] switches the scanning
direction.
• During a scan, you can change the operating band, scan
edge, and so on, in the Quick Menu window.
• The scan continuously runs, even if you push [MENU] or
[QUICK] during a scan.
