Icom D-STAR ID-31A; D-STAR ID-31E, Инструкция по эксплуатации

Страница: 32 / 80

23
5
BASIC OPERATION
New2001 New2001
■
Setting a tuning step
The following tuning steps are selectable.
• 5.0 kHz • 6.25 kHz • 10.0 kHz • 12.5 kHz
• 15.0 kHz • 20.0 kHz • 25.0 kHz • 30.0 kHz
• 50.0 kHz • 100.0 kHz • 125.0 kHz • 200.0 kHz
D Tuning step selection
q
Push [V/MHz] to select VFO mode, if necessary.
w
Push to open the Quick Menu screen.
e
Push D-pad( E ) to select “TS,” and
then push
D-pad(Ent).
D-pad
( � )
(Ent)
r
Rotate [DIAL] to select the desired
tuning step.
t
Push
D-pad(Ent) to save the setting
and exit the Quick Menu screen.
■
Setting a frequency
q
Push [V/MHz] to select VFO mode, if necessary.
w
Rotate [DIAL] to select the desired frequency.
• The frequency changes according to the selected tuning steps.
See the previous content to set the tuning step.
• When VFO mode is selected, push [V/MHz] then rotate
[DIAL] to change the frequency in 1 MHz steps. Or push [V/MHz]
again for 10 MHz* steps. (* Depending on versions, 10 MHz
tuning step is selectable.) Push [V/MHz] again to cancel it.
25 kHz tuning step
[DIAL]
The frequency changes accord-
ing to the selected tuning step.
After pushing [V/MHz] in the
VFO mode, [DIAL] changes the
frequency in 1 MHz or 10 MHz
steps.
[DIAL]