FMX 300X P-SERIES USER MANUAL
9
3.
Safety Information
•
This device must be installed by qualified service personnel or system
installation personnel.
•
Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
•
Do not disassemble or modify the thermal device.
•
Do not point the imager (with or without the lens cover) at intensive energy
sources, e.g. devices that emit laser radiation, or the sun. This can affect
the accuracy of the camera, and cause damage to the detector.
Using the
sun shield is highly advised.
•
Do not use the imager in an ambient temperature outside of the operation
range. High/low temperatures can cause damage to the device.
•
Prior to start of the device, make sure that the power supply is properly
connected. If the power supply is connected incorrectly, the device may
be damaged.
•
Do not place any objects on the power cord, and do not place the device
where the power cord can be easily touched.
•
Avoid placing the power cables and electrical wiring in places where they
will be tread upon or pressed, especially the connecting points leading from
the plug, power socket, or other unit.
•
Ensure the device is firmly affixed to when installing on walls or ceilings.
•
Do not get water or salt water on the device or permit the device to get
wet. Damage to the device may occur.
•
Remove any water or moisture on the device before you install it. Damage
to the device may occur.
•
Clean the case with a damp cloth and a weak soap solution. Do not use
abrasives, isopropyl alcohol, or solvents to clean the case or lens/screen.
•
Be careful when cleaning the infrared lens. Do not clean the infrared lens
too vigorously. This can damage the anti-reflective coating.
•
Avoid condensation. Taking the imager from cold to hot will cause
condensation in thermal imager. To protect the imager, power on the
device and wait until it becomes warm enough for the condensation to
evaporate.
•
Keep device out of reach of children.
•
Storage: If you do not use the imager for a long period of time, put the
device in a cool and dry environment. Store the device in an ambient
temperature of -40 °C to 70 °C (-40 °F to 158 °F).
•
This product is a precise electronic device that must be handled with care
during use, storage, and transportation to prevent dangerous actions such
as the device being hit by external force, or falling from heights.
