ICE TECH PS
15
IMPORTANT!
Supply socket must be properly earthed. Be sure to check standard for country where appliance
is going to be installed.
4.6. We recommend
Levelling
Place machine where it is required and level it ONCE all four legs have been
Space requirements
There should be a 150 mm gap on sides and top of the machine so as to allow air to circulate
and prevent heat build-up.
Float valve level
This valve is factory set, but may need to be adjusted if mains water pressure is very high or
very low. To do so, loosen the two small crews which connect the micro
support. Move micro-switch as required and tighten screws. Water level
below the evaporator coil to, otherwise there may be difficulty in releasing cubes in winter.
Note that if mains pressure is subject to large fluctuations, it will be difficult to maintain a
constant water level, in this case it may
mains line.
ICE TECH PS Technical Service Manual
Supply socket must be properly earthed. Be sure to check standard for country where appliance
Place machine where it is required and level it ONCE all four legs have been
There should be a 150 mm gap on sides and top of the machine so as to allow air to circulate
This valve is factory set, but may need to be adjusted if mains water pressure is very high or
very low. To do so, loosen the two small crews which connect the micro-
switch as required and tighten screws. Water level
below the evaporator coil to, otherwise there may be difficulty in releasing cubes in winter.
Note that if mains pressure is subject to large fluctuations, it will be difficult to maintain a
constant water level, in this case it may be advisable to install a pressure regulator on the water
Technical Service Manual
Supply socket must be properly earthed. Be sure to check standard for country where appliance
Place machine where it is required and level it ONCE all four legs have been fixed.
There should be a 150 mm gap on sides and top of the machine so as to allow air to circulate
This valve is factory set, but may need to be adjusted if mains water pressure is very high or
-switch to the steel
must be about 5 mm
below the evaporator coil to, otherwise there may be difficulty in releasing cubes in winter.
Note that if mains pressure is subject to large fluctuations, it will be difficult to maintain a
be advisable to install a pressure regulator on the water
