Ice vulcan, Руководство по обслуживанию, Страница: 113 / 252

Rev AA Maintenance 6-2
ICE Vulcan Service Manual
Maintenance Item Maintenance Method Maintenance Interval
Label sensor Clean with 70%
Isopropyl alocohol Once monthly or as required
Examine rollers (tamp
pad if applicable) for
adhesive build-up or
excessive dust Clean with 70% Isopropyl
alocohol to remove dust and
adhesive buildup. Carefully
remove any Labels adhered to
web path components. After every two to three rolls
of labels, or more often if
required.
Clean external surfaces Clean with low pressure air or
wipe with soft cloth. Once monthly or as required
Product sensor Clean lens with soft cloth Once weekly
Inspect
electrical
connections Visual inspection Once monthly or as required
Inspect for loose screws,
covers and other
hardware Visual inspection Once monthly or as required
Belts Visual inspection for wear Every six months/500 Rolls
Clean dust and debris
from internal
components Clean with air (canned air
only; Do not use high
pressure shop air) As required
Verify that all modules
and accessories are
securely fastened Visual inspection Once monthly
For systems using tamp applicator module
Check filter/regulator
for water or oil
collection Visual Inspection. Drain if
necessary. Eliminate source
of contamination. Once weekly
Examine air supply and
all connections for leaks Visual Inspection. Correct if
necessary Once weekly
Table 6-1: Preventive Maintenance Schedule (Continued)
Note: Harsh or dirty environments may require shorter intervals between preventive
maintenance routines.
Replacement Instructions
When you order a spare part kit, the replacement instructions of the respective spare part
are provided along with the kit. For more information, contact ICE and refer to Chapter,
“Support and Training” for the contact information.