Ice VAC WD 20, Руководство по эксплуатации и обслуживанию

Страница: 24 / 32

24
Check the wear of the front rubber blade on the squeegee body; if
the edge of the rubber that is in contact with the floor is worn replace
it as follows:
1. Take the device to the dedicated maintenance area.
ATTENTION : The place this operation is carried out should
comply with current environmental protection regulations.
2. Take all necessary steps to ensure that the device is in a safe
condition (see MACHINE SAFETY ’”).
ATTENTION : these operations must be carried out using
protective gloves to avoid any possible contact with the edges
or tips of metal objects.
3. Remove the vacuum hose (1) from the vacuum nozzle (2) on the
squeegee body ( Fig.1 ).
4. Fully loosen the knobs (3) in the squeegee body pre-assembly
( Fig.2 ).
5. Remove the squeegee body from the slits in the squeegee
connector ( Fig.3 ).
6. Free the rubber-pressing blades (9) from the squeegee body, by
releasing the hook (10) ( Fig.9 ).
7. Remove the front rubber-pressing blades (9) ( Fig.10 ).
8. Remove the rubber (5) and replace it ( Fig.11 ).
9. Proceed in reverse to replace the rubber.
Check the wear of the rear rubber blade on the squeegee body; if
the edge of the rubber that is in contact with the floor is worn replace
it as follows:
1. Take the device to the dedicated maintenance area.
ATTENTION : The place this operation is carried out should
comply with current environmental protection regulations.
2. Take all necessary steps to ensure that the device is in a safe
condition (see MACHINE SAFETY ’”).
ATTENTION : these operations must be carried out using
protective gloves to avoid any possible contact with the edges
or tips of metal objects.
3. Remove the vacuum hose (1) from the vacuum nozzle (2) on the
squeegee body ( Fig.1 ).
4. Fully loosen the knobs (3) in the squeegee body pre-assembly
( Fig.2 ).
5. Remove the squeegee body from the slits in the squeegee
connector ( Fig.3 ).
6. Free the rear rubber-pressing blades (11) from the squeegee
body, using the hook (12) ( Fig.12 ).
7. Remove the front rubber-pressing blades (11) ( Fig.13 ).
8. Remove the rubber (6) and replace it ( Fig.14 ).
9. Proceed in reverse to replace the rubber.
CONTROLLING AND CLEANING THE FABRIC FILTER
The careful cleaning of the fabric filter guarantees a longer life span
of the appliance's vacuum circuit, ensuring a better floor cleaning
performance. To clean the fabric filter, proceed as follows:
1. Take the device to its maintenance area.
ATTENTION : The place this operation is carried out should
comply with current environmental protection regulations.
2. Take all necessary steps to ensure that the device is in a safe
condition (see MACHINE SAFETY ’”).
ATTENTION
: You are advised to always wear protective
gloves, to avoid the risk of serious injury to your hands.
3. Free the vacuum head from the collection tank by releasing the
hooks (1) on the side of the collection tank ( Fig.1 ).
4. Using the handle (2) on the vacuum head unit ( Fig.2 ), remove the
vacuum head unit from the collection tank.
5. Lay the head gently on the floor.
6. Remove the fabric filter (3) ( Fig.3 ).
7. Vacuum the fabric filter with another vacuum cleaner.
8. Clean the fabric filter with an air jet from a distance of more than
20cm.
9. To refit the fabric filter carry out the operations in the reverse
order.
10
12
5
6
9
11
9
11
9
12
11
14
10
13