SAFETY PRECAUTION
2
ICE IM3
OPERATOR
Carefully read and understand this manual before operating this machine.
This machine must be grounded!
This machine shall be grounded while in use to protect theoperator from electric shock.
grounding provides a path of least resistance for electric current. This machine is equipped
with a cord having an equipment-grounding conductor
and grounding plug. The plug must be
plugged into an appropriate outlet that is properly installed and grounded in accordance with all
local codes and ordinances. Do not remove the ground pin under any circumstances.
This machine is for use on a nominal 220-volt circuit
and has a grounding plug that resembles the plug
illustrated in Figure. Make sure that the machine is
connected to an outlet having the same configuration as
the plug. No adapter should be used with this machine.
This machine is intended for commercial use. It is constructed for use in an indoor environment
and is nor intended for any other use. Use only recommended accessories.
1. Do not operate machine:
– Unless trained and authorized.
– Unless you have read and
– In flammable or explosive areas.
understand the operators manual.
– With a damaged cord or plug
– With the use of extension cords.
– If not in proper operating condition.
– In outdoor areas and standing water.
2. Before operating machine:
– Make sure all safety devices are in place and operating properly.
3. When using machine:
– Do not run machine over cord.
– Do not pull machine by cord or plug.
– Do not pull cord around
– Do not unplug by pulling on the cord.
sharp edges or corners.
– Do not stretch cord.
– Do not handle plug with wet hands.
– Keep cord away from heated surfaces.
– Report machine damage or faulty
operation immediately.
T
o avoid electrical shock,please replace the power cord immediately if any damage is
being detected. The replacement must be performed only by an authorized person or
by our customer service center.
4. Before leaving or servicing machine:
– Turn off machine.
– Unplug cord from outlet.
5. When servicing machine:
– Unplug cord from outlet.
– Use manufacturer supplied or
approved replacement parts.
