ice-watch ICE solar power, Быстрый старт

Страница: 1 / 8

SETTING THE TIME
1. Gently pull the winder out to the 1st position.
2. Turn the winder to set the hour and minute hands to the correct positions.
3. The second hand starts again when the winder is pushed back into its normal position.
Hour hand
Second hand
Minute hand
1st position
Normal winder position
Environment
Charging time
to work for
one day
Charging time
for steady
operation
Charging time
if the battery is
empty
Under direct sunlight Fine
weather
2 min 15 min 5 hours
Under direct sunlight Cloudy
weather
8 min 1,5 hours 20 hours
20cm under
fluorescent lamp
25 min 4 hours 60 hours
Interior lighting 100 min 35 hours /
What will happen if the battery becomes low ?
When the power reserve becomes low, the second hand moves every two seconds.
Please charge the watch by exposing the dial to light.
After the watch is charged, the second hand will move normally.
Getting started
Press
the winder.
Remove the plastic
stopper (in the direction
of the arrow).
Instructions
The watch must be serviced regularly in order for it to work correctly. The length of time between
services will vary depending on the model, climate and the care you take of your watch. As a
general rule, we recommend the following steps so that you can keep your watch in tip-top
condition for as long as possible.
- Temperature: avoid temperatures below 0°C (30°F) or above 35°C (100°F).
- Avoid prolonged exposure to sun, steam, contact with alcohol, detergents, perfume or
cosmetic products to prevent distorsion, discoloration or any damaging reaction.
- Do not use any watch button while under water to prevent water from entering the
mechanism.
The information contained in this document belongs to ICE Universal Ltd and may not be
reproduced without its authorisation.
ENGLISH