Serious Connections
TM
ICCONS™ GAS TOOL GT-3 & GT-3ST USER MANUAL
8
D. Preparing the fuel cell
Caution !
• Never attempt to use fuel cell from
other manufacturer.
• Do not remove the cap when it is
unused.
• Never drill a hole on the fuel cell.
• Do not inhale the gas. Breathing
in the gas could cause sleepiness,
dizziness or nausea.
• The fuel cell is not refillable, do not
attempt to refill the gas.
Steps:
First ensure to use the corect colour
valve, the colour of the rim for GT-3
/ GT-3ST should be blue.
1. Detach the cap, attach the valve by
pushing in the front edge.
2. Pushing the rear edge until it has
“clicked”.
NOTE:
• Make sure the fuel cell valve is
attached firmly, if not, gas leakage
may occur and create hazards to
users and bystanders.
E. Installing and removing fuel cell
Caution !
• Make sure the trigger is not held
while inserting fuel cell.
• Empty fasteners in the magazine
before installing fuel cell.
• Do not press on the surface ground
while installing.
Steps:
1. Push up and pull to open the fuel
door.
2. Insert the fuel cell, direct the jet
nozzle into the adaptor.
3. Put the can door over the valve and
push it down to latch.
4. For removing fuel cell, reverse the
above steps.
F. Loading the pins
Caution !
• Make sure the trigger is not held
while loading the pins.
• Do not press on the surface ground
while loading.
Steps:
1. Pull the follower holder to the
bottom of the magazine, until it locks at
the bottom.
2. Load the pins into the slit in the rear
of the magazine until they reach the top
of pin stopper.
3. Further pull the follower holder,
press the button on the pin carrier
