Brushless Motor Driver SEH400RB
6.Function setting of external control port.
6.1 Start and stop
EN and GNDE are disconnect by default, When the power is turned on, the
motor will not rotate. There are two ways to start the motor:
1. Press START to start and STOP to stop the motor.
2. Connect EN and GNDE. A switch or PLC can be added between EN and
GNDE to control the motor start and stop. See right.
6.2 Direction control.
Here are two methods to control the direction.
1. Through the panel MODE->P-03.
2. Disconnect F/R and GNDE, motor runs clockwise.
Connect F/R and GNDE, motor runs anti-clockwise.
6.3 Speed regulation mode.
6.3.1. Knob speed regulation.(Default method.)
6.3.2 MODE->P-01->SET->2 to select speed regulation with keys
, press page up or page down to select
request speed.
6.3.3
In addition to using the built-in potentiometer knob on the panel for speed regulation, the
external
port SV
can be used for the following settings for speed regulation. To start, set MODE->P-01->SET->1.
