IC Realtime F Series, Руководство пользователя

Страница: 19 / 31

19
3 Installation
This series IPC can be put on the table to realize surveillance. Or you can use the bracket or the in-
ceiling installation to realize the hang function. Please refer to the steps listed below.
3.1 Device Installation
Step 1
Use the inner hexagonal wrench (provided) to loose the four inner hexagon screws in the dome cover
and then open the cover. See Figure 3-1.
Figure 3-1
Step 2
Put the camera lens facing the monitor area (The lens tilt angle ranges from 10 to 90 degrees). Please
make sure the U-slot centre surface of the black internal enclosure shall be vertical to the monitor area.
Draw out the cable exit and four screw holes in the installation position according to the device
pedestal. Dig the four plastic expansion bolt hole and cable exit. Insert the four plastic expansion bolts
into the screw holes
Step 3
Adjust the camera lens to the proper monitor angle and then draw the cable through the cable exit you
just dug in the ceiling (wall). Line up the four screw holes in the device pedestal to the four plastic
expansion bolt holes in the installation position. Put the four self-tapping screws in the device pedestal
and then use the screwdriver to secure the screws in the four plastic expansion bolts firmly. See
Figure 3-2.