18
Chapter 3
– Initial operation
Fill with regenerative salt
– if necessary!
■ For a water hardness level of more than 21° dH, use only
special IRA salt (Art.No.: 103 006).
■ Never fill cleaner or other types of processing media
into the salt receptacle!
This may cause the water softening system to malfunction.
Topping up regenerative
salt
1. Open the lid in the washing chamber.
2. Before the initial operation, fill in half a liter of water into the salt
receptacle so that the salt dissolves.
3. Fill the storage receptacle completely. The storage receptacle holds
approximately 1.0 kg of salt.
4. Ensure that the opening for filling salt is clean from any
remaining salt as well as any overflowing brine, in order that
the cap may be replaced tightly.
5. Screw the cap back on.
WARNING!
After the initial filling up of the salt receptacle, no additional water
is required.
■
You can top up the salt at any time.
■
Rinse away any remaining salt in the washing chamber with
tap water before the next operation of the unit!
Water softening
Salt supply full
– symbol is green
Salt supply exhausted
– symbol is orange