IC Bus Gasoline CE Series, Руководство по эксплуатации и обслуживанию

Страница: 197 / 241

Maintenance Instructions
Consult your IC Bus ® dealer or IC Bus ® Service Manual for the
proper procedures for filling and bleeding the system.
The power steering fluid filter is located inside the power steering
reservoir. To remove the filter, unscrew the large cap on the
power steering reservoir and unscrew the filter. Reverse the
procedure to install the new filter.
Refer to the Lubrication and Maintenance Interval Chart at the
back of this section for the fluid and filter replacement intervals.
Transmission
Transmission Fluid Level
1. Hot fluid level
2. Cold fluid level
• Check fluid level with the parking brake applied, the
engine running at idle speed, and the transmission in
Neutral.
Consider the transmission fluid temperature
when determining the correct level.
• When the transmission fluid is cold, the fluid level should
fall within the COLD run band. When the transmission
fluid is hot, the fluid level should fall within the HOT
run band. Add fluid as required.
Do not overfill or the
transmission will overheat.
• Check the shift linkage for proper operation.
• Check operation of transmission neutral safety switch.
Try to start the vehicle in all shift selector positions. The
starter should ONLY operate when the shift selector is in
Neutral, or Park, if supplied.
• Refer to the Lubrication and Maintenance Interval Chart
and the Lubricant and Sealer Specifications chart at
the end of this section for information on automatic
transmission fluids and fluid and filter change intervals.
Tires
Tire Warnings
WARNING
To prevent personal injury and / or death,
or property damage,
for field maintenance,
only inflate and load tires to the maximum of
the least-rated tire on the axle.
Due to tire
manufacturers re-marking tires to conform to the
SI (metric) system, tires marked with old and new
loads or inflation pressures could be placed on
the same vehicle.
183