IC Bus BE Series, Руководство по эксплуатации и обслуживанию

Страница: 172 / 239

Maintenance
wear, and handling. Refer to AXLE U-BOLT NUT TORQUE
CHART at the end of this section for torque specifications.
Check the rear axle oil level. Proper oil level minimizes gear
wear, heat and damage to the wheel bearings and seals. The
oil level should be at the lower edge of the level inspection hole
when the vehicle is on level ground. Add oil as necessary.
Refer to the LUBRICATION AND MAINTENANCE INTERVAL
CHART and The LUBRICANT AND SEALER SPECIFICATIONS
CHART at the end of this section for additional information.
Body
Inspect the undercoating of school buses annually and recoat as
required.
Refer to Section 2 – Vehicle Inspection Guide and the
LUBRICATION AND MAINTENANCE INTERVAL CHART at
the end of this section for items to be inspected / serviced and
recommended service intervals.
Brakes
General Information
All new IC Buses are manufactured with non-asbestos brake
linings.
However, exposure to excessive amounts of brake
material dust may be a health hazard.
WARNING
To prevent vehicle damage, personal injury and /
or death, pay strict attention to the following: if
your vehicle is equipped with Automatic Traction
Control or any type of locking or limited slip
differential, power will be transmitted to the
opposite wheel should one of the wheels slip.
Both wheels must be raised free of the ground
should it be necessary to operate one wheel with
the vehicle stationary; otherwise, the wheel that
is not raised will pull the vehicle off its support.
WARNING
To prevent personal injury and / or death, avoid
breathing brake lining fiber dust. Always use a
respirator while performing brake maintenance.
Follow precautions listed below.
WARNING
To prevent property damage, personal injury,
and / or death, always check and maintain
brakes in proper condition and adjustment.
Out-of-adjustment brakes could cause reduced
braking ability.
160