IC Bus BE Series, Руководство по эксплуатации и обслуживанию

Страница: 156 / 239

Roadside Emergencies
Lowering the Hood
NOTE: Make sure that the hood has no tools / parts / people
in its path of motion.
Use the hood handle and push the hood backward over center
and allow it to settle into lowered position.
Engage the latches at both sides of cowl.
Emergency Starting Using Jumper Cables
WARNING
To prevent property damage, personal injury,
and / or death, the following procedures must be
performed exactly as outlined, otherwise a fire or
a battery explosion could occur.
CAUTION
To prevent damage to vehicle electronic
components, voltage supplied to a vehicle's
electrical system must never exceed 16.0 volts.
This voltage must not be exceeded when the
ignition switch is in the OFF, ACC, or IGN position
or during engine cranking.
The most reliable
means for jump starting a vehicle is to use
batteries connected so as to provide 12 volts.
Never use an electric welder.
1. Remove metal rings or watches and do not allow metal
tools to contact positive terminal of battery to prevent
shorting of the electrical system.
2. Place transmission in Neutral and set parking brake in
both vehicles.
3. Shut off lights, heater, air conditioner and any other
electrical loads in both vehicles.
144