IBM xSeries 100, Руководство по диагностике и обслуживанию

Страница: 92 / 126

Removing the front USB connector assembly
To remove the front USB connector assembly, complete the following steps.
Spring clips
Orientation tab
Retaining tab
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 55.
2. Turn off the server and all peripheral devices; then, disconnect the power cords
and all external cables.
3. Remove the cover (see “Removing the cover” on page 57).
4. Remove the bezel (see “Removing the bezel” on page 59).
5. Note the routing of the front USB connector assembly cable; then, disconnect it
from the system board (see “System-board internal connectors” on page 8 for
the location of the front USB connector).
6. Press in on the retaining tab and rotate the power switch/LED bracket toward
the right; then, pull the bracket away from the server.
7. From the front of the power switch/LED bracket, squeeze the spring clips on the
sides of the front USB connector assembly; then, pull the assembly from inside
the bracket to remove it.
8. If you are instructed to return the front USB connector assembly, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
76
IBM xSeries 100 Type 8486: Problem Determination and Service Guide