IBM xSeries 100, Руководство по диагностике и обслуживанию

Страница: 19 / 126

Features and specifications
The following information is a summary of the features and specifications of the
server. Depending on the server model, some features might not be available, or
some specifications might not apply.
Table 1. Features and specifications
Microprocessor:
v
Intel
®
Pentium
®
4 or Celeron
Processor
v 1 MB Level-2 or 256 KB level-2
cache
v 800 MHz front-side bus (FSB) or 533
MHz front-side bus
Note: Use the Configuration/Setup
Utility program to determine the type
and speed of the microprocessor.
Memory:
v
Minimum: 256 MB
v
Maximum: 8 GB
v
Types: PC2-4200, double-data-rate 2
(DDR2) with ECC
v
Connectors: four dual inline memory
module (DIMM) connectors, two-way
interleaved
Drives: (depending on your model)
v
Diskette: (optional) 1.44 MB (two
mode)
v
Hard disk drive: SATA
v
One of the following IDE drives:
– CD-ROM
– CD-RW (optional)
– DVD-ROM (optional)
– DVD/CD-RW combo (optional)
Expansion bays: (depending on your
model)
v Two 5.25-in. bays (one CD or DVD
drive installed)
v
One 3.5-in. removable-media drive
bays (optional)
v
Two 3.5-in. hard disk drive bays (one
hard disk drive installed)
Expansion slots:
v One PCI Express x1
v One PCI Express x8
v Two PCI 32-bit/33 MHz
Video controller : ATI ES1000 video
controller with 16 MB SDRAM video
memory on the system board
Fans: Two speed-controlled fans
Power supply: One 310 watt (90-240 V
ac)
Important: Make sure that the ac power
supply input voltage is set to the right level
(between 110 V ac and 220 V ac) for your
geographic location before powering on
the system.
Size:
v Height: 438 mm (17.24 in.)
v Depth: 497 mm (19.57 in.)
v Width: 205 mm (8.07 in.)
v
Weight: 14 kg (31 lb) to 17 kg (37.48 lb)
depending upon configuration
Integrated functions:
v Broadcom 5721 10/100/1000 Ethernet
controller on the system board with
RJ-45 Ethernet port
v Two serial ports
v One parallel port
v Two-port Serial ATA controller
v Four Universal Serial Bus (USB) v2.0
ports (two on front and two on rear)
v Keyboard port
v Mouse port
v ATA-100 single-channel IDE controller
v
ATI ES1000 video
– Compatible with SVGA and VGA
– 16 MB video memory
Diagnostic LEDs:
v
Fans
v
Memory
v
Microprocessor
Acoustical noise emissions:
v Sound power, idling: 5.0 bel
v Sound power, operating: 5.5 bel
Environment:
v
Air temperature:
– Server on: 10° to 35°C (50° to 95°F)
Altitude: 0 to 914 m (2998.0 ft)
– Server off: 0° to 60°C (-32° to 140°F)
Altitude: 0 to 2133 m (7000.0 ft)
v Humidity (operating and storage): 8% to
80%
Heat output:
Approximate heat output in British thermal
units (Btu) per hour
v
Minimum configuration: 379 Btu (111 watts)
per hour
v
Maximum configuration: 853 Btu (250 watts)
per hour
Electrical input:
v Sine-wave input (50 or 60 Hz) required
v
Input voltage and frequency ranges
manually selected
v
Input voltage low range:
– Minimum: 100 V ac
– Maximum: 127 V ac
v
Input voltage high range:
– Minimum: 200 V ac
– Maximum: 240 V ac
v
Input kilovolt-amperes (kVA) approximately:
– Minimum: 0.15 kVA (all models)
– Maximum: 0.59 kVA
Notes:
1. Power consumption and heat output vary
depending on the number and type of
optional features installed and the
power-management optional features in
use.
2. These levels were measured in controlled
acoustical environments according to the
procedures specified by the American
National Standards Institute (ANSI) S12.10
and ISO 7779 and are reported in
accordance with ISO 9296. Actual
sound-pressure levels in a given location
might exceed the average values stated
because of room reflections and other
nearby noise sources. The declared
sound-power levels indicate an upper limit,
below which a large number of computers
will operate.
Chapter 1. Introduction
3