IBM x3800 - System - 8865, Руководство пользователя

Страница: 137 / 196

Replacing the top cover, bezel, and front cover
To install the top cover, bezel, and front cover, complete the following steps:
1. Make sure that all internal cables are correctly routed.
2. Set the cover on top of the server so that approximately 13 mm (0.5 inch)
extends from the rear.
3. Make sure that the cover-release latch is up.
4. Slide the top cover forward and into position, pressing the release latch closed.
5. To install the bezel, tilt the bezel and insert the bottom tabs of the bezel into the
matching slots in the server chassis and push the top of the bezel toward the
server until the retention tabs snap into place.
6. (Tower model only) To install the front cover, tilt the front cover and insert the
bottom tabs of the front cover into the matching slots in the bezel and push the
top of the cover toward the server until the locking tabs snap into place; then,
lock the front cover.
Removing the adapter
To remove a PCI or PCI-X adapter, complete the following steps.
Tab
Adapter-
retention
latch
Attention
LED
(yellow)
Power
LED
(green)
PCI-X retaining bar
PCI-X divider
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 115.
Chapter 4. Removing and replacing server components
121