IBM WebSphere DataPower XC10, Руководство по установке

Страница: 34 / 52

a. Place the rear bracket of the rail against the rear column of the rack frame.
The rear column should be between the facing plates of the bracket.
b. With your thumb, press and hold the blue release tab.
c. With your index finger, push the blue lever toward the middle of the rack.
The facing plates separate to expose the retractable pins.
d.
Continue pushing the lever until the retractable pins are fully exposed and
are locked into the open position.
e. Align and insert the retractable pin into the appropriate holes in the rack
frame.
f.
Press the blue release tab to close the facing plates. The facing plates should
close against the column of the rack frame.
3. Secure the left rear of the rail to the rack. Use the following procedure:
a. Insert a standard rack screw through the rear column in the rack frame to
the built-in nut on the angle bracket of the rail.
b. Use a medium Phillips screwdriver to tighten the standard rack screw.
4. Insert the left front of the rail, as shown in Figure 5 on page 15.
a.
Align the front bracket of the rack with the front column of the rack frame.
b. With your thumb, press and hold the blue release tab.
c.
With your index finger, push the blue lever toward the middle of the rack.
The facing plates separate to expose the retractable pins.
d. Continue pushing the lever until the retractable pins are fully exposed and
are locked into the open position.
e. Align and insert the retractable pin into the appropriate holes in the rack
frame.
f. Press the blue release tab to close the facing plates. The facing plates should
close against the column of the rack frame.
a
b
c
Figure 4. Rear rail attaching to the rack frame
14
IBM WebSphere DataPower XC10: Installation Guide