IBM Universal Tape Library, Руководство пользователя, Страница: 23 / 96

16. Connect the power cords to the power supplies and the power source.
17. Install the tape cartridges. For more information, see “Installing tape cartridges”
on page 14.
18. Turn on the library. For more information, see “Turning the library on and off”
on page 14.
19. Configure the library. For more information, see “Configuring the library” on
page 15.
Installing Fibre Channel tape drive cables
Notes:
1. Fibre Channel cables are not provided and must be purchased separately.
2. This document describes basic Fibre Channel installations. More complicated
installations such as SANs, switches, and hubs are beyond the scope of this
document.
If you have installed a Fibre Channel tape drive, complete the following steps:
1. Connect the Fibre Channel host interface cable to the host server.
2. Connect the Fibre Channel host interface cable to the tape drive.
Host system
SCSI jumper cables SCSI terminator
Figure 11. Installing the SCSI host interface cables
Host system
Figure 12. Installing the Fibre Channel host interface cables
Chapter 2. Installing and configuring the library
13