IBM Universal Tape Library, Руководство пользователя, Страница: 18 / 96

v
The use of a grounding system is recommended. For example, wear an
electrostatic-discharge wrist strap, if one is available.
v Handle the device carefully, holding it by its edges or its frame.
v
Do not touch solder joints, pins, or exposed circuitry.
v
Do not leave the device where others can handle and damage it.
v
While the device is still in its static-protective package, touch it to an unpainted
metal surface for at least 2 seconds. This drains static electricity from the
package and from your body.
v
Remove the device from its package and install it immediately without setting
down the device. If it is necessary to set down the device, put it back into its
static-protective package. Do not place the device on a metal surface.
v Take additional care when handling devices during cold weather. Heating reduces
indoor humidity and increases static electricity.
Returning a device or component
If you are instructed to return a device or component, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to you.
Required tools
Make sure that the following tools are available:
v 3 mm hex wrench
v 2.5 mm hex wrench
v #1 flat-blade screwdriver
v Electrostatic-discharge wrist strap
Installing the Universal Tape Library
To install the Universal Tape Library, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 7.
2. Make sure that the host system is turned off and that the host system is not
connected to power.
3. If you are installing a multiple library stack, go to “Stacking libraries” on page
15. Then, continue with step 4.
4. Assemble the rack shelves (see Figure 6 on page 9):
a. Loosely attach the rack shelves to the rack rails, using four M5 x 10 hex
screws.
Note: The rack shelves must be installed inside the rack rails.
b. With the arrow on each rail adapter pointing up, attach a rail adapter to the
front and back of each rack mount shelf, using two M5 x 10 hex screws for
each rail adapter.
8
Universal Tape Library User’s Guide