IBM Turboways 155, Инструкция по установке и эксплуатации

Страница: 15 / 36

Verifying Adapter Available for Use
To verify that your newly installed TURBOWAYS 155 PCI UTP ATM Adapter is
available for use, follow the steps below:
1. If necessary, turn your system unit power on.
2. Log in as root.
3. At the prompt, type
lsdev -Cc adapter | grep atm
and press Enter.
4. A list of adapters displays. Verify that the TURBOWAYS 155 PCI UTP ATM
Adapter is in
Available
mode. If your TURBOWAYS 155 PCI UTP ATM
Adapteris not available, run the diagnostics utility described in the Diagnostics
section of Appendix A, “Troubleshooting” on page A-1.
Connecting the TURBOWAYS 155 PCI UTP ATM Adapter to the Network
Before using your TURBOWAYS 155 PCI UTP ATM Adapter, connect it to an ATM
switch or concentrator.
Note: The connector on the adapter conforms with the ATM Forum standard. If
your switch connector pinout is not compatible with this standard, obtain or create a
cable that conforms to the standard.
Chapter 2. Installing the ATM155
2-3