IBM TS7650G PROTECTIER DEDUPLICATION GATEWAY, Руководство пользователя, Страница: 31 / 248

5. Change the server IP address, netmask, default gateway, and host name
factory-set values, to the values specific to the customer environment.
a.
You are prompted, one at a time to enter the following values. At each
prompt, type the new value and then press <Enter>:
v Customer Network IP address
v Customer Network netmask
v Customer Network default gateway
v Customer Network hostname (The fully qualified hostname of the server.
For example:
hostname.domain.com
)
After you enter the hostname, the system automatically starts the network
configuration process. The following status messages display:
Configuring network [ Done ]
Updated network configuration successfully
update updateNetwork ended successfully
The system automatically restarts the vtfd service, and you are returned to
the command prompt.
6. Change the system name from the one assigned during manufacturing to one
specific to the customer environment. To do so:
a. From the ProtecTIER Configuration (...) menu, select the Update System
Name
option. Type the number of your choice and press Enter.
b. When prompted, type the new system name of the server and press Enter.
Note: The system name that was assigned to the server in manufacturing
appears in brackets after the prompt. For example: [PORTLAND]. After you
enter the system name, the system automatically starts the Update the
System Name
process. The following status message appears:
Changing system name [ Done ]
Updated system name successfully
UpdateSystemName ended successfully
End Processing Procedure Successfully
Press Enter to continue and return to the command prompt.
7. When you are finished, go on to Chapter 4, “Installing ProtecTIER Manager,”
on page 25.
Configuring the application IP interfaces
This section describes how to update the IP communication interfaces on a node.
About this task
Note: Customizing the network configuration on a node can also be done using
ProtecTIER Manager. If ProtecTIER Manager is already installed on the system, go
to “Customizing the network configuration of a node” on page 38.
ProtecTIER exposes virtual interfaces to the host, such as a media server with the
plug-in installed. In version 3.4.1, the physical Ethernet ports are assigned to one
virtual application interface. Currently, the physical ports are assigned to virtual
interface eth0 or eth1, depending on the server configuration. This assignment
option is used to group several physical interfaces into a single virtual interface,
and create a bond configuration of several physical interfaces. Each virtual
interface used must be configured with a corresponding IP address.
Chapter 2. Completing the ProtecTIER system setup for new installations
11