IBM TS7650G PROTECTIER DEDUPLICATION GATEWAY, Руководство пользователя, Страница: 135 / 248

Setting the weekly replication timeframe
Scheduling a timeframe for replication to take place for all policies allows you to
maximize your system's resources and prioritize between backups and replication.
About this task
Defining a replication timeframe gives replication the highest priority with the
maximum system resources used to complete the replication during the
“replication window”. You can define a replication timeframe using the Set
Replication Timeframe
dialog. Outside of the set timeframe replication is off and
does not run.
If you choose backup as the priority, or no replication timeframe is defined,
replication runs continuously all day, but on low priority, thereby consuming
minimal resources from the system.
You can also limit the replication throughput through the Replication Rate Limits
window (see “Setting the replication rate limit” on page 116).
Note: If you define a timeframe both on the source and on the destination
repositories, you need to adjust both to the same time settings.
To set the replication timeframe:
Procedure
1. From the Systems Management view, select Replication > Set Replication
timeframe
. The Set Replication timeframe dialog box is displayed.
2. Select an option:
v Prioritized backup – Replication is active, but is of low priority.
v No backup priority – Replication is off and only activated during defined
timeframe.
ts760859
Figure 20. Set replication time frame window
Chapter 13. Native replication management (for FSI)
115