IBM TotalStorage SAN256N Director 2045-N16, Руководство по установке и обслуживанию, Страница: 102 / 157

SAN256N Director 2045-N16
82
5. On the Entperprise Manager Client, select the Boards tab and then right click the
previously inserted board. Select Versions from the drop down menu.
6. Scroll over to the Valid column on the far right to confirm that the code is valid.
7. If the Flash version and Firmware Version do not match, perform a code load from
the Code Load button on the toolbar.To put the board online, right click the
appropriate board and then select Configuration from the drop down menu.
8. Select the Online radio button then click OK.
9. You will see the following message:
Do you want to set the Admin mode?
10. Select Yes. Admin mode change may take about one minute.
11. You will see the following message:
Are you sure you want to continue.
12. Select Yes.
13. You will see the following message:
Changes were applied successfully.
14. Click OK. You will be returned to the Boards tab and the Navigation Tree menu.
15. Check the following indicators on the TCM modules:
– Check the Heartbeat LED blinking pattern to verify that blinking pattern is normal
(normal is on/off once per second.)
– The green Online LED is ON.
– Ensure there are no OFLN (Offline) messages in the scrolling displays.
– On the Boards Tab ensure that the TCM module has a status of Online.
TFIO blade replacement procedures
Use the following procedures to do a hot swap replacement of a TFIO blade. Figure 36
on page 83 provides a visual reference.
Attention: Refer to safety notices before starting an installation.
Attention: Use a properly attached ESD wrist strap when handling any TFIO,
TSW, or TCM module, otherwise damage to equipment may result.