IBM TotalStorage L10, Справочное руководство CLI

Страница: 30 / 96

2006 Model L10 Storage Switch
18
Displaying events (root/config/sys/events)
This command displays the event log entries (up to 3000 messages) generated by the
switch. For a list of the severity levels and event messages, see Appendix A. Event
messages on page 67.
To view the event log:
From the System Configuration menu (root/config/sys), type
events
and press E
NTER
.
To continue to list event messages:
Press E
NTER
.
To view all remaining event log messages:
Type
a
and press E
NTER
.
To quit viewing the event log messages:
Press C
TRL
-X.
Configuring the event log severity filter (root/config/sys/sev)
This command sets the event log’s severity filter level. When set, the event log will only
record events that are equal to or higher than the specified severity level. The default
setting is 7.
Each event has a particular severity level ranging between ‘emergency’ and ‘info’. Users
can designate the lowest severity level at which to report an event in the event log. (For
example, if the severity level for event log reporting is designated as ‘alert’, the switch
logs messages of the ‘alert’ or the ‘emergency’ severity level only—’emergency’ is the
only severity level higher than ‘alert’.)
To change the event log severity level:
1. From the System Configuration menu (root/config/sys), type
sev
and press E
NTER
.
The current severity level value appears in brackets before the command prompt.
2. Type the desired selection (
1-7
) and press E
NTER
.
Table 11. Event log severity filter settings
Setting Description
1 emergency
2 alert
3 critical
4 error
5 warning
6 notify
7 info