IBM TotalStorage L10, Справочное руководство CLI

Страница: 16 / 96

2006 Model L10 Storage Switch
4
Initial switch setup
After logging in to the CLI for the first time, perform the following switch configuration
tasks:
• Verify the switch’s network settings.
• Change the switch’s password.
Note: Until the default switch password is changed, any user with knowledge of the
default password can make changes.
• Verify the switch’s date and time settings.
• Reset the switch to enable the changes to the switch’s configuration.
To verify the switch’s current network settings:
From the Network Configuration menu (root/config/network), type
show
and press
E
NTER
.
The switch ships with the following default IP settings:
• IP Address: 192.168.1.129
• Netmask: 255.255.255.0
• Gateway: 192.168.1.1
To change the IP address setting:
1. From the Network Configuration menu (root/config/network), type
ip
and press
E
NTER
.
2. Type the new IP address and press E
NTER
.
To change the network mask setting:
1. From the Network Configuration menu (root/config/network), type
mask
and press
E
NTER
.
2. Type the new network mask setting and press E
NTER
.
To change the default gateway setting:
1. From the Network Configuration menu (root/config/network), type
gateway
and
press E
NTER
.
2. Type the new default gateway setting and press E
NTER
.
Once the network settings are configured, type
save
and press E
NTER
. A message
appears confirming the request. Type
y
and press E
NTER
to save the current settings.
To change the password:
1. From the Configuration menu (root/config), type
password
and press E
NTER
.
2. Type the current password and press E
NTER
.
3. Type the new password and press E
NTER
.
Note: The password must be between 6 and 25 characters in length and is case
sensitive.
4. Type the new password again and press E
NTER
.