IBM TotalStorage FAStT700, Руководство пользователя

Страница: 36 / 100

Turning on the power
Important: You must turn on the drive enclosures before the FAStT700 Storage
Server. The controllers might not recognize the correct configuration if the hard disk
drives are turned on after the FAStT700 Storage Server. For instructions on turning
on the drive enclosures, refer to the drive enclosure documentation.
Note: Always wait at least 30 seconds between the time you turn off a power
switch and the time you turn on the power again.
Check the system documentation for the hardware devices that you intend to turn
on, and then determine the proper startup sequence. Turn on the power to each
device in the following order:
v
Supporting devices
v
Drive enclosures
v
FAStT700 Storage Server
v
Host
If you are restoring power to the FAStT700 Storage Server after an emergency
shutdown or power outage, go to “Overtemperature condition and power supply
shutdown” on page 30.
Use the following procedure to turn on the FAStT700 Storage Server and connected
devices:
1. Turn on the power to the supporting devices (for example, Ethernet switches,
Fibre Channel switches, and management stations).
2. Turn on the drive enclosure. The controllers might not recognize the correct
configuration if the drives are powered up after the storage server. For
instructions on turning on the drive enclosures, refer to the drive enclosure
documentation.
3. Turn on the power to the FAStT700 Storage Server, as follows:
a. Verify that all communication and power cables are plugged into the back of
the FAStT700 Storage Server and to a properly grounded ac electrical
outlet.
b. Turn on the power-supply switches on the back of the FAStT700 Storage
Server (see Figure 22 on page 19). You must turn on both power-supply
18
IBM
®
TotalStorage
™
FAStT700 Fibre Channel Storage Server: User’s Guide