IBM totalstorage fastt100, Инструкция по установке, эксплуатации и обслуживанию, Страница: 81 / 160

Perform the following to cable the power cords:
1. Wrap the strain-relief clamp around the power cord approximately 20 cm (8 in.)
from the power supply connection end.
2. Attach the power-supply nut, and tighten it securely.
3. Connect the power cord to the power supply.
4. Plug the power cord into a properly grounded electrical outlet.
Note: To maintain power redundancy, plug the storage server’s right and the
left power supplies into two independent external power circuits through
ac distribution units inside a rack cabinet or directly into external
receptacles. Similarly, the right and left power supplies of the FAStT drive
enclosures attached to the FAStT100 should be plugged into the same
two independent external power circuits as the FAStT100. See Figure 47
on page 52 for an example of redundant power cabling.
AC power
connector
AC power
switch
Strain-relief
clamp
Lever
-
f10ug027
Figure 46. Power cord locations
Chapter 3. Cabling the storage server
51