IBM TotalStorage EXP100, Инструкция по установке, использованию и обслуживанию

Страница: 56 / 188

You can find the latest DS4000 controller firmware at the IBM DS4000
TotalStorage Support Web site:
www.ibm.com/servers/storage/support/disk/
9. Turn on the EXP100. See “Turning the EXP100 on and off” on page 58.
10. Turn on the DS4000 storage subsystem and use the DS4000 Storage
Manager 9.1 host software to verify the configuration.
Handling static-sensitive devices
Attention: Static electricity can damage electronic devices and your system. To
avoid damage, keep static-sensitive devices in their static-protective packages until
you are ready to install them.
To reduce the possibility of electrostatic discharge, observe the following
precautions:
v
Limit your movement. Movement can cause static electricity to build up around
you.
v Handle the device carefully, holding it by its edges or its frame.
v
Do not touch solder joints, pins, or exposed printed circuitry.
v Do not leave the device where others can handle and possibly damage the
device.
v While the device is still in its static-protective package, touch it to an unpainted
metal part of the system unit for at least two seconds. This drains static electricity
from the package and from your body.
v Remove the device from its package and install it directly into your system unit
without setting it down. If it is necessary to set the device down, place it in its
static-protective package. Do not place the device on your system unit cover or
on a metal table.
v Take additional care when handling devices during cold weather because heating
reduces indoor humidity and increases static electricity.
Preparing for installation
Complete the following steps to prepare the EXP100 for installation into a rack
cabinet.
1. Prepare the site to meet all area, environmental, power, and site requirements.
For more information, see “EXP100 operating environment” on page 21.
2. Move the EXP100 to the site.
Statement 4:
svc00146
18-32 kg (39.7-70.5 lbs) 32-55 kg (70.5-121.2 lbs) 55 kg ( 121.2 lbs)
CAUTION:
Use safe practices when lifting.
3. Remove the EXP100 from its shipping container and check the contents (see
“Inventory checklist” on page 14). If any items are missing, contact your IBM
reseller before proceeding.
30
IBM TotalStorage DS4000 EXP100 Storage Expansion Enclosure: Installation, User’s and Maintenance Guide
|
|
|
|