Note: The variables within brackets represent the default settings that your
information replaces.
v
Ethernet IP Address [10.77.77.77]:
Type the new Ethernet IP address.
v
Ethernet Subnetmask[0.0.0.0]:
Type the new Ethernet subnetmask.
v
Fibre Channel IP Address [none]:
Type the new fibre-channel IP address, if desired.
v
Fibre Channel Subnetmask[none]:
Type the new fibre-channel subnetmask if desired.
v
Gateway Address [172.17.1.1]:
Type the new gateway address.
v
Set IP address now? [y = set now, n = next reboot]:
Type
y
to set the IP address now.
9. Type the following command to verify that the address was set correctly:
ipAddrShow
10. After you verify the IP address, remove the serial cable and replace the
shipping plug in the serial port.
Note: Use the serial port only during the initial setting of the IP address and
for service purposes. Do not use the serial port during normal switch
operation or for regular maintenance.
11. Record the IP address for future reference.
Connecting and accessing the switch
Complete the following steps to connect the switch to the workstation using an
Ethernet cable (this can be a direct connection or through a network), and to
access the switch:
1. Remove the shipping plug from the Ethernet port.
2. Insert one end of an Ethernet cable in the Ethernet port.
3. Connect the other end of the Ethernet cable to the workstation or to an Ethernet
network that contains the workstation.
Note: You can now access the switch remotely, using Telnet or TotalStorage
Specialist. Ensure that the switch is not being modified simultaneously
from any other connections during the remaining steps.
4. Log on to the switch using Telnet. The default administrative logon is admin, and
the default password is password.
5. Modify the domain IDs if desired.
Note: The default domain ID is 1. If the domain ID is already in use when the
switch is connected to the fabric, the domain ID for the new switch is
automatically reset to a unique value. You can determine the domain IDs
that are currently in use by issuing the Telnet fabricShow command. For
more information about Telnet commands, see the IBM TotalStorage SAN
Fibre Channel Switch 3534 Model F08 Command Reference.
a. Type the following command to disable the switch:
switchDisable
b. Type the following command:
Chapter 3. Installing and configuring the 3534 Model F08
17
Содержание TotalStorage 3534-F08
