IBM TotalStorage 3534-F08, Руководство по установке

Страница: 32 / 81

a. Position a 3-hole bracket
4
at the end of one of the outer slides.
b. Attach the bracket using the 8-32 x 3/8 in. zinc screws
9
. Make sure that
the screw heads are inside the slides.
c. Place one of each of the following items on the outer end of the screw in the
order listed:
1) Washer flat No. 8
10
2) Washer, lock No. 8
11
3) Nut, hex, 8-32
12
d. Repeat steps 5a - 5b for the three remaining rail ends.
6. Install the outer (larger) slides in the rack, as shown in Figure 9.
a. At the desired height, install the five M5 nut clips
5
; put three in the front
of the rack and two in the back. The middle clip in the front of the rack is for
the locking ears.
b. Attach the slides using four M5 x 12 screws
7
.
c. Repeat steps 6a - 6b for the other rail.
7. Install the switch in the rack.
a. Position the switch in front of the rack and insert it into the rack by sliding
the inner slides on the switch into the outer slides on the rack. See
Figure 10 on page 15.
SJ000048
3
9
11
12
10
5
4
4
1
Figure 9. Mounting the fixed portion of the rail and the locking ears to the rack
14
IBM TotalStorage
™
SAN Fibre Channel Switch: 3534 Model F08 Installation Guide