IBM TotalStorage 3534-F08, Руководство по установке

Страница: 11 / 81

Safety and environmental notices
This section contains information about:
v Safety notices used in this book
v
Safety inspection for this product
v Environmental guidelines for this product
Safety notices and their translations
Safety notices are printed in English throughout this book.
v A Danger notice warns you of conditions or procedures that can result in death or
severe personal injury.
v
A Caution notice warns you of conditions or procedures that can cause personal
injury that is neither lethal nor extremely hazardous.
v
An Attention notice warns you of conditions or procedures that can cause
damage to machines, equipment, or programs.
For translations of danger and caution notices, see IBM TotalStorage SAN Fibre
Channel Switch 3534 Model F08 Translated Safety Notices, GC26-7459-00. The
notices are listed in numeric order based on their IDs, which are displayed in
parentheses at the end of each notice. See the following examples for the location
of the ID numbers.
DANGER
An electrical outlet that is not correctly wired could place a hazardous
voltage on metal parts of the system or the products that attach to the
system. It is the customer’s responsibility to ensure that the outlet is
correctly wired and grounded to prevent an electrical shock. (1)
CAUTION:
The 3534 Model F08 switch is designed to be installed by the customer, and is
certified as
″
customer setup
″
. Make sure that the system or rack into which
the switch will be installed is also designed and certified for customer setup;
if it is not, then the switch must be installed by a CE. (1)
Safety inspection
Perform the following safety checks to identify unsafe conditions. Be cautious of
potential safety hazards that are not covered in the safety checks. If unsafe
conditions are present, determine how serious the hazards are and whether you
should continue before correcting the problem.
CAUTION:
The 3534 Model F08 switch is designed to be installed by the customer, and is
certified as
″
customer setup
″
. Make sure that the system or rack into which
the switch will be installed is also designed and certified for customer setup;
if it is not, then the switch must be installed by a CE. (1)
Checking the machine
Perform the following external machine checks:
1. Verify that all external covers are present and are not damaged.
© Copyright IBM Corp. 2002
ix