IBM TotalStorage 2109 M12, Инструкция по установке и обслуживанию

Страница: 70 / 159

v
Ensure that the two dedicated electrical branch circuits are protected with a
circuit breaker that is in accordance with the local electrical codes.
v Ensure that the supply circuit, line fusing, and wire size are adequate according
to the electrical rating on the chassis nameplate.
v
Ensure that a licensed electrician installs the grounded outlets and that they are
compatible with the power cords.
v
Ensure that the M12 has access to a minimum airflow of 350 cubic feet per
minute.
v Ensure that the air temperature that is measured at the blower inlet does not
exceed 40°C (104°F ) during operation.
Ordering the lift tool
Important
The lift tool is required only when you install an additional M12 switch.
The ordering procedures for the lift tool vary depending on your location. You
should direct questions about these procedures to your regional specialist.
Note: The bridge tool (PN 18P5855), which is required for installation, is shipped
with a new or a replacement M12. The bridge tool, when installed, serves as
a temporary ramp between the lift tool and the M12 rails that are installed in
a Model C36 cabinet. You do not need to return the bridge tool when you are
done with it.
World trade locations
The following ordering procedures are for world trade locations:
v
Order the lift tool by using the parts order system, like any other part.
v Use the following part numbers when you order:
– Lift tool: PN 09P2481
– 24–inch load plate: PN 11P4369
v
You do not record parts usage.
v
Return the lift tool and the 24–inch load plate to the parts center after you
complete the installation or removal of the M12.
United States locations
In the United States, call UPS Logistics at 800–528–6046 to order the lift tool and
the 24–inch load plate.
Note: For the SSR branch and territory, the United States cannot order the lift tool
or 24–inch load plate through the parts order system. UPS Logistics are
used to ship and return the lift tool and 24–inch load plate.
Use the following part numbers when you order:
v
Lift tool: PN 09P2481
v 24–inch load plate: PN 11P4369
40
IBM TotalStorage SAN Switch: 2109 Model M12 Installation and Service Guide