IBM totalstorage 200, Руководство по обслуживанию

Страница: 76 / 180

Installing a non-hot-swap drive or CD-ROM
Note: The appliance’s electromagnetic interference (EMI) integrity and cooling are
both protected by having the non-hot-swap drive bays covered or occupied.
When you install a drive, save the filler panel from the bay in case you later
remove the drive and do not replace it with another.
To install a non-hot-swap drive (5.25-inch, removable media) in one of the
non-hot-swap drive bays:
1. Review the safety precautions in “Translated safety notices” on page 124.
2. Switch off the appliance and peripheral devices and then remove the cover
and the bezel (see “Removing the cover (Model 200)” on page 51 for details).
3. Remove the filler panel from the bay opening by pulling the filler panel away
from the appliance. You do not need the filler panel when you have a drive
installed in the drive bay.
4. If the drive is a laser product, observe the following safety precaution:
Statement 3
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices,
or transmitters) are installed, note the following:
v
Do not remove the covers. Removing the covers of the laser product
could result in exposure to hazardous laser radiation. There are no
serviceable parts inside the device.
v
Use of controls or adjustments or performance of procedures other
than those specified herein might result in hazardous radiation
exposure.
5. Touch the static-protective bag containing the drive to any unpainted metal
surface on the appliance; then, remove the drive from the bag and place it on
a static-protective surface.
Blue slide rails
Slide rails
Filler panel
Non-hot-swap bay
Non-hot-swap drive
Figure 21. Installing a non-hot-swap drive
60
Models 200 and 225 Service Guide