IBM totalstorage 200, Руководство по установке оборудования

Страница: 29 / 152

Removing the cover
Removing the Model 200 cover:
To remove the left-side cover of the Model 200:
1. Review the information in “Preparing to install a memory module” on page 14.
2. Switch off the appliance and all attached devices and disconnect all external
cables and power cords.
3. Slide the cover-release lever on the front of the appliance to release the cover;
then, slide the cover toward the rear of the appliance about 25 mm (1 in.). Move
the top edge of the cover out from the appliance; then, lift the cover off the
appliance. Set the cover aside.
Attention: For proper cooling and airflow, replace the cover before switching
on the appliance. Operating the appliance for extended periods of time (over 30
minutes) with the cover removed might damage appliance components.
Left-side cover
Cover
release
lever
Figure 5. Removing the cover of the Model 200
Chapter 2. Installation procedures
15