IBM System x3690 X5, Руководство по обслуживанию, Страница: 396 / 464

Replacing the MAX5 air baffle
To replacing the MAX5 air baffle, complete the following steps:
1.
Read the safety information that begins on page “Safety” on page vii and
“Installation guidelines” on page 261.
2. Align the air baffle next to DIMM 1 and hook the hinge on the air baffle
underneath the system board; then, insert the tab on the other end of the air
baffle into the tab slot on the system-board wall until it is firmly in place.
Alignment tab
Slot
Release
latch
Tab
3. Replace the system-board tray (see “Replacing the MAX5 system-board tray
assembly” on page 395).
4.
Reinstall the bezel (see “Replacing the MAX5 bezel” on page 376).
Removing the MAX5 information panel assembly
To remove the information panel assembly, complete the following steps:
1. Read the safety information and installation guidelines, see “Safety” on page vii
and “Installation guidelines” on page 261.
2. Turn off the host server (see “Turning off the server” on page 17) and all
attached peripheral devices. Disconnect all power cords; then, disconnect all
external cables from the server. Disconnect all power cords from the MAX5;
then, disconnect all external cables from the MAX5 as necessary to replace the
device.
3. Remove the bezel (see “Removing the MAX5 bezel” on page 376).
4.
Grasp the blue release latches on the system-board tray handles and pull the
latches in opposite directions; then, rotate the handles to the open position.
378
System x3690 X5 Types 7147, 7148, 7149, and 7192: Problem Determination and Service Guide