IBM System x3610, Руководство по диагностике и обслуживанию

Страница: 93 / 144

Installing a DVD drive
To install the replacement DVD drive, complete the following steps.
1. Follow the instructions that come with the drive to set any jumpers or switches.
2. Place the drive in the drive-cage enclosure. Replace the four screws that hold
the drive in place.
3. Lower the drive-cage enclosure into the server; then, slide the enclosure toward
the front of the server until it is flush with the front of the chassis.
4. Replace the two screws that secure the drive-cage enclosure to the chassis.
5. Reconnect the cables that you disconnected in “Removing a DVD drive” on
page 74. Be sure to connect the SATA cable to the SATA 4 connector on the
system board (see “System-board optional-device connectors” on page 8 for the
location of the SATA connectors).
6. Install the cover (see “Installing the cover” on page 46).
7. Slide the server into the rack and tighten the rack release thumbscrews.
8. Reconnect the external cables; then, reconnect the power cords and turn on the
peripheral devices and the server.
Chapter 4. Removing and replacing server components
75