IBM System x3100 M3, Инструкция по установке и эксплуатации

Страница: 26 / 94

DVD drive activity
LED(green)
Simple-swap
hard disk drive
DVD-eject
button
Front information
panel
Power-on LED
Power-control
button
Hard disk drive
activity LED
System error
LED
USB 2
USB 1
Power-control button and power-on LED
Press this button to turn the server on and off manually or to wake the
server from a reduced-power state. When this LED is lit, it indicates that the
server is turned on. When this LED is off, it indicates that ac power is not
present, or the power supply or the LED itself has failed. When this LED is
blinking, it indicates that the system is in the ACPI S4 or S5 system status.
Attention: If you are connecting the server to an ac power source for the
first time, do not press the power-control button until the power LED
flashes.
Hard disk drive activity LED
When this LED is flashing rapidly, it indicates that a hard disk drive is in
use.
System-error LED
When this amber LED is lit, it indicates that a system error has occurred.
An LED on the system board might also be lit to help isolate the error.
Detailed troubleshooting information is in the
Problem Determination and
Service Guide on the IBM System x Documentation CD.
USB connectors
Connect USB devices to these connectors.
DVD-eject button
Press this button to release a CD or DVD from the DVD drive.
DVD drive activity LED
When this LED is lit, it indicates that the DVD drive is in use.
10
System x3100 M3 Type 4253: Installation and User’s Guide