IBM System x3100 M3, Инструкция по установке и эксплуатации

Страница: 25 / 94

v
Automatic Server Restart (ASR) logic supporting a system restart when the
operating system becomes unresponsive
v
Automatic server restart after a power failure, based on the BIOS setting
v
Availability of microcode level
v
Boot-block recovery
v
Built-in monitoring for fan, power, temperature, and voltage
v
Built-in, menu-driven configuration and setup programs
v CD-based diagnostic programs
v Cooling fan with speed-sensing capability
v Customer support center that is available 24 hours a day, 7 days a week
2
v Error codes and messages
v Error correcting code (ECC) memory
v Error logging of POST failures
v Integrated Ethernet controller
v Intelligent Platform Management Interface (IPMI) 2.0 support
v Memory change messages posted to the error log
v Menu-driven setup, system configuration, and redundant array of independent
disks (RAID) configuration programs
v
Power-on self-test (POST)
v
Read-only memory (ROM) checksums
v
SDRAM with serial presence detect (SPD)
v
Wake on LAN capability
Server controls, LEDs, and power
This section describes the controls, light-emitting diodes (LEDs), and connectors on
the front and rear of the server, and how to turn the server on and off.
Note: The illustrations in this document might differ slightly from your model.
Front view
The following illustrations show the controls, LEDs, and connectors on the front of
the server.
2. Service availability will vary by country. Response time varies; may exclude holidays.
Chapter 1. The System x3100 M3 server
9