IBM System x iDataPlex dx360 M2, Руководство по диагностике и обслуживанию

Страница: 220 / 264

I/O enclosure
Two-slot
riser card
1. Touch the static-protective package that contains the PCIe riser-card assembly
to any unpainted metal surface on the outside of the I/O enclosure; then,
remove the PCIe riser-card assembly from the package.
2. Place the PCIe riser-card assembly on the mounting studs inside the I/O
enclosure.
3. Install the four retaining screws.
4. Install and cable the PCIe adapter, if you removed one from the PCIe riser-card
assembly (see “Installing an adapter in the I/O enclosure” on page 152).
5. Install the PCIe adapter bay cover on the I/O enclosure (see “Installing the PCIe
adapter bay cover” on page 143).
6. Install the I/O enclosure on the system-board tray (see “Installing an expansion
enclosure on a system-board tray” on page 132).
7. Install the system-board tray in the chassis (see “Installing the system-board
tray in a 2U chassis” on page 127).
Removing a power-supply paddle card from the system-board tray
To remove a power-supply paddle card from the system-board tray, complete the
following steps.
204
System x iDataPlex dx360 M2: Problem Determination and Service Guide