IBM System x iDataPlex dx360 M2, Руководство по диагностике и обслуживанию

Страница: 211 / 264

1. Install the PCIe riser-card assembly (see “Installing a PCIe riser-card assembly
in the I/O enclosure” on page 203).
2. Install the PCIe adapters, if you removed any (see “Installing an adapter in the
I/O enclosure” on page 152).
3. Install the I
2
C multiplexer card (see “Installing an I
2
C multiplexer card” on page
163).
4. Install the 2x2 2.5-inch SAS/SATA backplane (see “Installing a 2x2 2.5-inch
SAS/SATA backplane” on page 185).
5. Install the 2.5-inch SAS/SATA drive cage (see “Installing a 2.5-inch SAS/SATA
drive cage” on page 148).
6. Install the power-supply paddle card, if you removed one (see “Installing a
power-supply paddle card in an expansion enclosure” on page 179).
7. Install the hard disk drives, if you removed any (see “Removing and installing a
hard disk drive” on page 139).
8. Install the I/O enclosure on the system-board tray (see “Installing an expansion
enclosure on a system-board tray” on page 132).
Removing an I/O enclosure configured with 3.5-inch simple-swap hard
disk drives
To remove an I/O enclosure that is configured with 3.5-inch simple-swap hard disk
drives, complete the following steps.
Chapter 5. Removing and replacing server components
195