IBM System x iDataPlex dx360 M2, Руководство по диагностике и обслуживанию

Страница: 208 / 264

Removing a front-panel assembly
To remove the front-panel assembly, complete the following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 123.
2. If the system-board tray is installed in a chassis, remove it (see “Removing the
system-board tray from a 2U chassis” on page 126 or “Removing the
system-board tray from a 3U chassis” on page 128).
3. If an expansion enclosure is installed, remove it (see “Removing an expansion
enclosure from a system-board tray” on page 131); otherwise, remove the
system-board tray cover (see “Removing the system-board tray cover” on page
125).
4. Note the cable routing and where each cable is connected and disconnect the
cables that are near the front-panel assembly to improve accessibility.
5. Press the release tab and slide the front-panel assembly away from the front of
the system-board tray.
6. Note the cable routing and disconnect the front-panel assembly cables from the
system board and power-supply paddle card.
7. Open the cable retention latches and carefully pull the assembly and cables
from the system-board tray.
8. If you are instructed to return the front-panel assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
192
System x iDataPlex dx360 M2: Problem Determination and Service Guide